固化剂环氧地坪它能很好的弥补现有地面如环氧树脂地面、金刚砂耐磨地面的一些不足，在一些物流仓库、生产车间等交通非常频繁的场合，硬化、防尘效果它具有其它地面无可比似的优势1、固化剂环氧地坪施工前注意清洁.施工时，需要注意地面保持干燥和干净，如果地面上有杂物需要打扫干净，湿地面要隔天施工，新地面建议15天左右再施工。

Curing agent floor can make up for some shortcomings of the existing floor such as epoxy resin floor, diamond wear-resistant floor. In some logistics warehouses, production workshops and other occasions where traffic is very frequent, hardening and dust-proof effect of it has the incomparable advantages of other floors. 1. The curing agent floor should be cleaned before construction. Pay attention to the ground to keep dry and clean, if there is debris on the ground to clean up, wetland surface to be constructed every other day, the new ground proposal about 15 days to re-construction. 
2、固化剂环氧地坪施工的渗透固化处理：

2. Osmotic solidification of solidified agent floor construction:

使用混凝土密封固化剂A材料洒在地面硬化处理，以保证地面完全渗透，直至地面充分吸收为止。

Use concrete sealant A material sprinkled on the ground hardening treatment to ensure that the ground is fully penetrated until the ground is fully absorbed.

3、固化剂地坪施工材料施工顺序：

3. The construction sequence of curing agent floor construction materials:

混凝土密封固化剂A材料喷洒之后等地面晾干，再洒B材料，施工方法和A材料一样

After spraying concrete sealant A material, the ground is dried and then sprayed with B material. The construction method is the same as that of A material.

4、固化剂地坪施工的三磨

4. Three grinding of solidified agent floor construction

1.粗磨：使用50-200号 地坪磨片(水磨或干磨)。

1. rough grinding: use No. 50-200 floor grinding disc (water mill or dry grinding).

2.细磨：使用200-300号地坪磨片(水磨或干磨);

2. fine grinding: use No. 200-300 floor grinding disc (water mill or dry grinding);

3.精磨：使用500-1500号 磨片、水磨或干磨，4.清洗、晾干：彻底把地面清洗干净，用吸水机吸净晾干。

3. Fine grinding: use 500-1500 grinding, water grinding or dry grinding, 4. cleaning, drying: thoroughly clean the ground, with a water absorber to clean and dry.

混凝土密封固化剂地坪施工时的注意事项

Matters needing attention in the construction of concrete sealing hardener floor

本品呈弱酸性，皮肤不宜长期接触;施工时建议配戴防尘口罩，乳胶或塑料手套，并注意不要喷洒到设备或者玻璃上。

This product is weak acidic, the skin should not be long-term contact; construction is recommended to wear dust masks, latex or plastic gloves, and be careful not to spray on equipment or glass.